Faster access than browser!
44 relations: Aurora (protocol), Bit error rate, Capacitive coupling, Clock recovery, CoaXPress, Common Public Radio Interface, Common-mode rejection ratio, Crosstalk, Current-mode logic, Cyclic redundancy check, Data-dependent jitter, Differential signaling, Electrical termination, Electromagnetic interference, Emphasis (telecommunications), Eye pattern, Fibre Channel, Field-programmable gate array, FIFO (computing and electronics), Frame (networking), Gigabit Ethernet, InfiniBand, Interlaken (networking), Intersymbol interference, Jitter, Network packet, Octet (computing), Open Base Station Architecture Initiative, Parts-per notation, Passive optical network, PCI Express, Phase-locked loop, RapidIO, SerDes, Serial ATA, Serial Attached SCSI, Serial digital interface, Signal integrity, Synchronous optical networking, Transmission line, XAUI, 10 Gigabit Ethernet, 64b/66b encoding, 8b/10b encoding.
Aurora (protocol)
The Aurora Protocol is a link layer communications protocol for use on point-to-point serial links.
New!!: Multi-gigabit transceiver and Aurora (protocol) · See more »
Bit error rate
In digital transmission, the number of bit errors is the number of received bits of a data stream over a communication channel that have been altered due to noise, interference, distortion or bit synchronization errors.
New!!: Multi-gigabit transceiver and Bit error rate · See more »
Capacitive coupling
Capacitive coupling is the transfer of energy within an electrical network or between distant networks by means of displacement current between circuit(s) nodes, induced by the electric field.
New!!: Multi-gigabit transceiver and Capacitive coupling · See more »
Clock recovery
In serial communication of digital data, clock recovery is the process of extracting timing information from a serial data stream to allow the receiving circuit to decode the transmitted symbols.
New!!: Multi-gigabit transceiver and Clock recovery · See more »
CoaXPress
CoaXPress (CXP) is an asymmetric high speed serial communication standard over coaxial cable.
New!!: Multi-gigabit transceiver and CoaXPress · See more »
Common Public Radio Interface
The Common Public Radio Interface (CPRI) standard defines a flexible interface between Radio Equipment Controllers (REC) and Radio Equipment (RE).
New!!: Multi-gigabit transceiver and Common Public Radio Interface · See more »
Common-mode rejection ratio
The common mode rejection ratio (CMRR) of a differential amplifier (or other device) is a metric used to quantify the ability of the device to reject common-mode signals, i.e., those that appear simultaneously and in-phase on both inputs.
New!!: Multi-gigabit transceiver and Common-mode rejection ratio · See more »
Crosstalk
In electronics, crosstalk is any phenomenon by which a signal transmitted on one circuit or channel of a transmission system creates an undesired effect in another circuit or channel.
New!!: Multi-gigabit transceiver and Crosstalk · See more »
Current-mode logic
Current mode logic (CML), or source-coupled logic (SCL), is a differential digital logic family intended to transmit data at speeds between 312.5 Mbit/s and 3.125 Gbit/s across standard printed circuit boards.
New!!: Multi-gigabit transceiver and Current-mode logic · See more »
Cyclic redundancy check
A cyclic redundancy check (CRC) is an error-detecting code commonly used in digital networks and storage devices to detect accidental changes to raw data.
New!!: Multi-gigabit transceiver and Cyclic redundancy check · See more »
Data-dependent jitter
Data-dependent jitter (DDJ) is a specific class of timing jitter.
New!!: Multi-gigabit transceiver and Data-dependent jitter · See more »
Differential signaling
Differential signaling is a method for electrically transmitting information using two complementary signals.
New!!: Multi-gigabit transceiver and Differential signaling · See more »
Electrical termination
In electronics, electrical termination is the practice of ending a transmission line with a device that matches the characteristic impedance of the line.
New!!: Multi-gigabit transceiver and Electrical termination · See more »
Electromagnetic interference
Electromagnetic interference (EMI), also called radio-frequency interference (RFI) when in the radio frequency spectrum, is a disturbance generated by an external source that affects an electrical circuit by electromagnetic induction, electrostatic coupling, or conduction.
New!!: Multi-gigabit transceiver and Electromagnetic interference · See more »
Emphasis (telecommunications)
Typically, prior to some process, such as transmission over cable, or recording to phonograph record or tape, the input frequency range most susceptible to noise is boosted.
New!!: Multi-gigabit transceiver and Emphasis (telecommunications) · See more »
Eye pattern
In telecommunication, an eye pattern, also known as an eye diagram, is an oscilloscope display in which a digital signal from a receiver is repetitively sampled and applied to the vertical input, while the data rate is used to trigger the horizontal sweep.
New!!: Multi-gigabit transceiver and Eye pattern · See more »
Fibre Channel
Fibre Channel, or FC, is a high-speed network technology (commonly running at 1, 2, 4, 8, 16, 32, and 128 gigabit per second rates) providing in-order, lossless delivery of raw block data, primarily used to connect computer data storage to servers.
New!!: Multi-gigabit transceiver and Fibre Channel · See more »
Field-programmable gate array
A field-programmable gate array (FPGA) is an integrated circuit designed to be configured by a customer or a designer after manufacturing hence "field-programmable".
New!!: Multi-gigabit transceiver and Field-programmable gate array · See more »
FIFO (computing and electronics)
FIFO is an acronym for first in, first out, a method for organizing and manipulating a data buffer, where the oldest (first) entry, or 'head' of the queue, is processed first.
New!!: Multi-gigabit transceiver and FIFO (computing and electronics) · See more »
Frame (networking)
A frame is a digital data transmission unit in computer networking and telecommunication.
New!!: Multi-gigabit transceiver and Frame (networking) · See more »
Gigabit Ethernet
In computer networking, Gigabit Ethernet (GbE or 1 GigE) is a term describing various technologies for transmitting Ethernet frames at a rate of a gigabit per second (1,000,000,000 bits per second), as defined by the IEEE 802.3-2008 standard.
New!!: Multi-gigabit transceiver and Gigabit Ethernet · See more »
InfiniBand
InfiniBand (abbreviated IB) is a computer-networking communications standard used in high-performance computing that features very high throughput and very low latency.
New!!: Multi-gigabit transceiver and InfiniBand · See more »
Interlaken (networking)
Interlaken is a royalty-free interconnect protocol.
New!!: Multi-gigabit transceiver and Interlaken (networking) · See more »
Intersymbol interference
In telecommunication, intersymbol interference (ISI) is a form of distortion of a signal in which one symbol interferes with subsequent symbols.
New!!: Multi-gigabit transceiver and Intersymbol interference · See more »
Jitter
In electronics and telecommunications, jitter is the deviation from true periodicity of a presumably periodic signal, often in relation to a reference clock signal.
New!!: Multi-gigabit transceiver and Jitter · See more »
Network packet
A network packet is a formatted unit of data carried by a packet-switched network.
New!!: Multi-gigabit transceiver and Network packet · See more »
Octet (computing)
The octet is a unit of digital information in computing and telecommunications that consists of eight bits.
New!!: Multi-gigabit transceiver and Octet (computing) · See more »
Open Base Station Architecture Initiative
The Open Base Station Architecture Initiative (OBSAI) was a trade association created by Hyundai, LG Electronics, Nokia, Samsung and ZTE in September 2002 with the aim of creating an open market for cellular network base stations.
New!!: Multi-gigabit transceiver and Open Base Station Architecture Initiative · See more »
Parts-per notation
In science and engineering, the parts-per notation is a set of pseudo-units to describe small values of miscellaneous dimensionless quantities, e.g. mole fraction or mass fraction.
New!!: Multi-gigabit transceiver and Parts-per notation · See more »
Passive optical network
A passive optical network (PON) is a telecommunications technology used to provide fiber to the end consumer, both domestic and commercial.
New!!: Multi-gigabit transceiver and Passive optical network · See more »
PCI Express
PCI Express (Peripheral Component Interconnect Express), officially abbreviated as PCIe or PCI-e, is a high-speed serial computer expansion bus standard, designed to replace the older PCI, PCI-X, and AGP bus standards.
New!!: Multi-gigabit transceiver and PCI Express · See more »
Phase-locked loop
A phase-locked loop or phase lock loop abbreviated as PLL is a control system that generates an output signal whose phase is related to the phase of an input signal.
New!!: Multi-gigabit transceiver and Phase-locked loop · See more »
RapidIO
The RapidIO architecture is a high-performance packet-switched, interconnect technology.
New!!: Multi-gigabit transceiver and RapidIO · See more »
SerDes
A Serializer/Deserializer (SerDes pronounced sir-deez or sir-dez) is a pair of functional blocks commonly used in high speed communications to compensate for limited input/output.
New!!: Multi-gigabit transceiver and SerDes · See more »
Serial ATA
Serial ATA (SATA, abbreviated from Serial AT Attachment) is a computer bus interface that connects host bus adapters to mass storage devices such as hard disk drives, optical drives, and solid-state drives.
New!!: Multi-gigabit transceiver and Serial ATA · See more »
Serial Attached SCSI
In computing, Serial Attached SCSI (SAS) is a point-to-point serial protocol that moves data to and from computer-storage devices such as hard drives and tape drives.
New!!: Multi-gigabit transceiver and Serial Attached SCSI · See more »
Serial digital interface
Serial digital interface (SDI) is a family of digital video interfaces first standardized by SMPTE (The Society of Motion Picture and Television Engineers) in 1989.
New!!: Multi-gigabit transceiver and Serial digital interface · See more »
Signal integrity
Signal integrity or SI is a set of measures of the quality of an electrical signal.
New!!: Multi-gigabit transceiver and Signal integrity · See more »
Synchronous optical networking
Synchronous optical networking (SONET) and synchronous digital hierarchy (SDH) are standardized protocols that transfer multiple digital bit streams synchronously over optical fiber using lasers or highly coherent light from light-emitting diodes (LEDs).
New!!: Multi-gigabit transceiver and Synchronous optical networking · See more »
Transmission line
In communications and electronic engineering, a transmission line is a specialized cable or other structure designed to conduct alternating current of radio frequency, that is, currents with a frequency high enough that their wave nature must be taken into account.
New!!: Multi-gigabit transceiver and Transmission line · See more »
XAUI
10 Gigabit Attachment Unit Interface (XAUI) is a standard for extending the XGMII (10 Gigabit Media Independent Interface) between the MAC and PHY layer of 10 Gigabit Ethernet (10GbE) defined in Clause 47 of the IEEE 802.3 standard.
New!!: Multi-gigabit transceiver and XAUI · See more »
10 Gigabit Ethernet
10 Gigabit Ethernet (10GE, 10GbE, or 10 GigE) is a group of computer networking technologies for transmitting Ethernet frames at a rate of 10 gigabits per second.
New!!: Multi-gigabit transceiver and 10 Gigabit Ethernet · See more »
64b/66b encoding
In data networking and transmission, 64b/66b is a line code that transforms 64-bit data to 66-bit line code to provide enough state changes to allow reasonable clock recovery and alignment of the data stream at the receiver.
New!!: Multi-gigabit transceiver and 64b/66b encoding · See more »
8b/10b encoding
In telecommunications, 8b/10b is a line code that maps 8-bit words to 10-bit symbols to achieve DC-balance and bounded disparity, and yet provide enough state changes to allow reasonable clock recovery.
New!!: Multi-gigabit transceiver and 8b/10b encoding · See more »
References
[1] https://en.wikipedia.org/wiki/Multi-gigabit_transceiver
