Quarter panel and Sheet metal
Shortcuts: Differences, Similarities, Jaccard Similarity Coefficient, References.
Difference between Quarter panel and Sheet metal
Quarter panel vs. Sheet metal
A quarter panel (British English: rear wing) is the body panel (exterior surface) of an automobile between a rear door (or only door on each side for two-door models) and the trunk (boot) and typically wraps around the wheel well. The similar front section between the door and the hood (bonnet), is called a fender, but is sometimes incorrectly also referred to as a quarter panel. Quarter panels are typically made of sheet metal, but are sometimes made of fiberglass, carbon fiber, or fiber-reinforced plastic. A quarter panel is typically a welded-on component of the unibody structure. Replacement of a sheet metal quarter panel typically requires it to be cut off the vehicle and a replacement part to be welded (or sometimes bonded) to the vehicle. Due to the high amount of specialized labor, a quarter panel may often be repaired rather than replaced by hammering the damaged area to a relatively flat surface and then applying a body filler to smooth out the damaged area to match the original surface. The panel is then usually painted and often clear coated. Sheet metal is metal formed by an industrial process into thin, flat pieces.
Similarities between Quarter panel and Sheet metal
Quarter panel and Sheet metal have 1 thing in common (in Unionpedia): Sheet metal.
The list above answers the following questions
- What Quarter panel and Sheet metal have in common
- What are the similarities between Quarter panel and Sheet metal
Quarter panel and Sheet metal Comparison
Quarter panel has 13 relations, while Sheet metal has 70. As they have in common 1, the Jaccard index is 1.20% = 1 / (13 + 70).
References
This article shows the relationship between Quarter panel and Sheet metal. To access each article from which the information was extracted, please visit:
Faster access than browser!
