Faster access than browser!
8 relations: Automotive industry, Ford Model A (1927–31), Ford Model T, Ford Motor Company, Internal combustion engine, Motor vehicle, Quarter panel, Transmission (mechanics).
Automotive industry
The automotive industry is a wide range of companies and organizations involved in the design, development, manufacturing, marketing, and selling of motor vehicles, some of them are called automakers.
New!!: Crossmember and Automotive industry · See more »
Ford Model A (1927–31)
The Ford Model A (also colloquially called the A-Model Ford or the A, and A-bone among rodders and customizers), was the second huge success for the Ford Motor Company, after its predecessor, the Model T. First produced on October 20, 1927, but not sold until December 2, it replaced the venerable Model T, which had been produced for 18 years.
New!!: Crossmember and Ford Model A (1927–31) · See more »
Ford Model T
The Ford Model T (colloquially known as the Tin Lizzie, Leaping Lena, or flivver) is an automobile produced by Ford Motor Company from October 1, 1908, to May 26, 1927.
New!!: Crossmember and Ford Model T · See more »
Ford Motor Company
Ford Motor Company (commonly referred to simply as "Ford") is an American multinational automaker headquartered in Dearborn, Michigan, a suburb of Detroit.
New!!: Crossmember and Ford Motor Company · See more »
Internal combustion engine
An internal combustion engine (ICE) is a heat engine where the combustion of a fuel occurs with an oxidizer (usually air) in a combustion chamber that is an integral part of the working fluid flow circuit.
New!!: Crossmember and Internal combustion engine · See more »
Motor vehicle
A motor vehicle is a self-propelled vehicle, commonly wheeled, that does not operate on rails, such as trains or trams and used for the transportation of passengers, or passengers and property.
New!!: Crossmember and Motor vehicle · See more »
Quarter panel
A quarter panel (British English: rear wing) is the body panel (exterior surface) of an automobile between a rear door (or only door on each side for two-door models) and the trunk (boot) and typically wraps around the wheel well. The similar front section between the door and the hood (bonnet), is called a fender, but is sometimes incorrectly also referred to as a quarter panel. Quarter panels are typically made of sheet metal, but are sometimes made of fiberglass, carbon fiber, or fiber-reinforced plastic. A quarter panel is typically a welded-on component of the unibody structure. Replacement of a sheet metal quarter panel typically requires it to be cut off the vehicle and a replacement part to be welded (or sometimes bonded) to the vehicle. Due to the high amount of specialized labor, a quarter panel may often be repaired rather than replaced by hammering the damaged area to a relatively flat surface and then applying a body filler to smooth out the damaged area to match the original surface. The panel is then usually painted and often clear coated.
New!!: Crossmember and Quarter panel · See more »
Transmission (mechanics)
A transmission is a machine in a power transmission system, which provides controlled application of the power.
New!!: Crossmember and Transmission (mechanics) · See more »
